Erik here from IN

[dseriesdrag]

Been on the forum for awhile now, just haven't posted. I've got an eh3 with a jdm xsi b16a, itr cams, and ctr y21 non lsd trans. I sold my turbo kit to buy my 03 accord 6sp trans, clutch, flywheel, intermediate shaft, and starter. Not too bad for $800. The rest of my swap should be sold next thursday so that I can buy everything else for my J swap.

Things I need to know:

1. Can I use a K shifter and cables, or do they have to be from the 6sp v6?

2. Does anyone else make mounts for this swap besides Hasport? Talked to EVS-One, but he doesn't have time to make a set.

3. About the ecu....I plan to buy a j32a2 from a cl type s. Do I need to use a type s ecu or does it matter?

4. Will the Hasport axles really only handle 200whp??? Anyone using them with luck, or are you using something else???

5. Are there any stock v6 parts that are needed to make this swap work besides the obvious engine, trans, ecu, harness? Will I need any hoses, lines, electrical items, etc....???

[wolydotmatrix]

I have a pterry detailed list of parts OE and aftermarket parts I used on my build.
http://www.honda-tekh.com/thread?id=3652

Welcome and good luck on your sale.

[dseriesdrag]

Thanks for the info. I've been watching your build, I just didn't know if there where any last minute oddball items that you forgot to list?

Nice build by the way ;D

[wolydotmatrix]

Odd-ball:
:98 Accord 4cyl upper radiator hose
:install water temp sensor for gauge in cluster in the crossover pipe between the heads
:relocate radiator and resivor
:Starter wire, used 2 civic wires and spliced them with an 80amp Stereo Fuse
:finding places for the ground straps to bolt in to the block from the chasis
:Damn intake tube, not alot of room under the hood
I am sure there is more, I am tired and a little buzzed.

[dseriesdrag]

Thanks for the info. All info helps.

BTW, congrats on getting it running!