PDA

View Full Version : J32A spec. questions

Screech`:)
02-05-2010, 12:23 AM
Where can I find info. on the J32A JDM motor. Do they run higher compression? Will all the sensors and transmission be the same as USDM? Or are these motors built very similarly with same hp ratings?
wolydotmatrix
02-05-2010, 01:40 AM
Where can I find info. on the J32A JDM motor. Do they run higher compression? Will all the sensors and transmission be the same as USDM? Or are these motors built very similarly with same hp ratings?

From what little information I have read there is only "slight" differences between the USDM and the JDM J32A. mainly plastic covers and the harness goes the other direction (RHD).
acidbath124
02-06-2010, 10:36 PM
i have been trying to find out the same thing i have a jdm motor in my car and a usdm motor in a garage and as far as i know the only difference i could find is the lower intake runners are different
Screech`:)
02-07-2010, 01:15 AM
I've only found a couple of pictures of the JDM version, and its hard to tell, but it looked as though the intake manifold was alittle different. It looked like a better design if I'm looking at the correct motor. I would just like to find some numbers with this motor.

http://images.craigslist.org/3nd3k13p15O35P55R1a1sbd78466d19521a61.jpg
http://img1.classistatic.com/cps/po/100120/114r4/2639jl4_27.jpeg
acidbath124
02-08-2010, 02:50 PM
thats a different manifold than whats on my engine but it cud have been switched i guess
Becoming
02-12-2010, 01:48 AM
That looks like an older Accord manifold, not the new CL/TL.
basil
02-12-2010, 09:16 PM
Do you guys think you could run a JDM J32a with a USDM harness and ECU without throwing a code or having any engine issues?
acidbath124
02-13-2010, 06:56 AM
yes you can but of course you have to do the same stuff to get rid of codes as you would with a usdm engine
RPM SYSTEMS
02-14-2010, 03:37 AM
the pic of the motors are just the base line of the CL/TL motors from japan . the funny thing is the U.S. has more 6 speed trannys come here , than they had in japan or china. more of there customer what the tip-tronic setup that the manual tranny. so almost all the motors you will see come out of these state side JDM motor shops is auto motors. not CL manual Type -S motors.

don
rpm systems