air conditioning

[crick_james]

i have searched on this site but can not and have not found anything. if there is a topic on this already please point me in the right direction. i am intrested in trading my 00 civic for a j32 96 integra, the car runs great and i love it. but it doesnt have a/c. anyone have a how to on this?

[splat]

It can be done, juts need to do a little fab work.

[wfoej6]

anyone???

I plan on doing the swap in an my DD EK and want to keep a/c? will the motor fit in fine the hasport mounts and the j-series compressor?

[kanekoaboi]

anyone???

I plan on doing the swap in an my DD EK and want to keep a/c? will the motor fit in fine the hasport mounts and the j-series compressor?

Has anyone done this, would be nice to have some guidlines to how this is done. I'd like to put a/c in my swap after i complete it. Thanks.

[1diesel2hondas]

I haven't read about anyone actually doing this but the rumor is you need a jseries compressor and custom lines.

[paton]

I have a j series compressor. $200

[IDon'tKnow]

A/C is A/C is A/C - If there is room for the compressor in your engine bay then you can run your A/C. If the Integra you are looking at has the controls, the condensor, and the lines all you will need is the compressor, the right belt, and some lines to tie the TL compressor into the original system.

I have a compressor sitting out in my shop; I'll give it to you for $135 shipped anywhere in the US.

[kanekoaboi]

I actually have everything to put it in just need to make the custom lines but I was worried about the fitment or placement of the condensor with the compressor in the stock position. Has anyone done it yet? Where's the best place to put the condensor?

[wolydotmatrix]

The Integra and EK chasis will be the easiest with the original height Hasport mounts (more room in the front between the engine and upper radiator supprt) In my EG I would have to move the compressor oposite the radiator, not much room there for condenser and fans assembly. from the looks of the DC's and the EK's there is about 1-3 more inches of clearance. Doen't look impossible but will require custom lines atthe very least.

The NEW lower mounts from hasport move the engine slightly forward as well to clear the steering rack, forward means less room. Just my 0.02

Adam