j32 bellhousing dimensions

[dornon13]

I am looking for some help from somebody with a transmission or block laying around. I am looking for two dimensions that I illustrated on the photo below. Basically I need from the center of the input shaft to the highest and the lowest point on the bell housing bolting surface. The dimensions don't have to be micrometer precise just a simple tape measurement u should be able to get it within 1/4 inch which will be fine for my purposes. From what I have seen in my searches these threads dont usually get very far so who ever can get these dimensions first I will cut them a few vinyl decals of their choosing for your trouble. Thanks in advance guys this is a great forum and I look forward to being a big part of it soon.

http://www.flickr.com/photos/58813160@N07/5393079514/
http://farm6.static.flickr.com/5091/5393079514_f707170c54.jpg

[dornon13]

Alright alot of you guys are home from work now lol go out to the garage and help me out :P

[Fred931931]

ill probably get the tranny out tomorow , if i do so , i will take you somme mesurement.

[dornon13]

You da man!

[dornon13]

Anyone?

[HickamHatch]

I will get them for you sometime this week. Everything is at my shop

[00crv6?]

from the top left bolt looking at the flywheel to the center of the crank is 8", from the center of the crank to the lower most bolts is 6.5", +/- 1/4". from a 2002.

[dornon13]

Thanks! Is that straight vertical or a straight line to the bolt hole?

[00crv6?]

the lower dimention is straight verticle, the top dimention straight verticle is 7.5". sorry, the graphics on the pic went to the bolt.
which porsche/vw transaxle are you bolting to your j? what vehicle is this intresting set-up going into?