EG cl type s 6sp swap 6800 rev limit???

[yeven_stas]

is this correct i put my car on the dyno and it hit rev limiter right under 6900? is this correct? i haven't got the tach converter from don yet will be in a few weeks but ive seen people reving past 7k and one at 7.7? how do you do that? or do i have a cel or in limp mode? no cel bulb on cluster or doesn't work and no way to check cel any idea how to wire a obd2 scan plug or where to get one?

thanks

[paton]

Without doing my research, I'm 95% sure that is the CL-S rev limit. The reason you see other vehicles revving past that is because the tach signal has bot been converted.

I'm assuming you watched the read-outs on the dyno computer and that's how you know?

You can find an OBD2 scan port an a 96-2001 Integra, or a 1996-2000 Civic. Look at the diagrams of both the Integra/Civic and CL-S and you'll see how to wire it in.

Wire you're MIL (Malfunction Indicator Lamp) so you know if you have a problem.

[yeven_stas]

thanks for the input

[Rajca]

my 03 cl 6spd hits the rev limiter at 7200 same was with my 02 tl-s